V2000-c Rfid Access Control User Manual

V2000-C Terminal Block ------------------------------------------------ +12V → Power supply positive GND → Power supply negative (common ground) NO → Normally open (to lock’s positive unlock wire) COM → Common (to lock’s negative / power supply GND) NC → Normally closed (rarely used with fail-secure locks) PUSH → Exit button (one side; other side to GND) SEN → Door contact sensor (to GND when door closed) ALARM → Optional alarm output BELL → Optional buzzer output

Enter a number from 0 to 99 (seconds). Note: 0 sets the relay to toggle/latch mode. Press # then * to exit. Access Modes Define how users gain entry to the property. Enter Programming Mode. Press 3 . Select your mode: 0 : Entry by Card Only 1 : Entry by Card OR PIN (Default) 2 : Entry by Card AND PIN combined Press # then * to exit. 5. Troubleshooting and Factory Reset Device is Beeping Continuously Tamper switch triggered or incorrect voltage supply. V2000-c Rfid Access Control User Manual

Enter Programming Mode -> Press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . Adding Users (Card or Keyfob) Enter Programming Mode. Press 1 + [Read Card] + # . Access Modes Define how users gain entry to the property

The V2000-C system is designed to be easy to use, with a simple and intuitive interface that allows administrators to manage access control with ease. The system can be operated using a variety of methods, including: Select your mode: 0 : Entry by Card

Connect the wire of the V2000-C to the Power Supply +12V.

Ensure you are using a 125 kHz EM-frequency card. Mifare 13.56 MHz cards are incompatible with the V2000-C standard reader.

1.0 Last Updated: 2026 Applies to: V2000-C Standalone RFID Access Control System