Fix: Ensure your Wi-Fi router broadcasts a 2.4GHz signal. The ESP32 chip on the MKS DLC32 board does not support 5GHz networks. If you need help setting up your engraving system, tell me:
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Set your engraving parameters: dimensions, speed (mm/min), and laser power mode (M3 or M4 dynamic power).
: Before starting any job, test the connection and ensure the software can communicate with your machine.
: A common bug in version 1.1.2 prevents users from clicking buttons after the initial download.
Once the software is installed, you need to establish communication with your hardware.
Looking for the official MKS Laser Tool Setup V1.1.2.exe ? This essential utility is designed for managing and upgrading Makerbase (MKS) laser engraving controllers, such as the DLC32 series. What is MKS Laser Tool?
Swap the USB cable for one that supports data transfer (not just charging). Reinstall the CH340 driver and restart your PC. Firmware Flash Fails midway
MKS Laser Tool is a utility software primarily used for configuring and flashing firmware on laser engraver motherboards, such as the