Kes Geyser Load Control Timer Manual New !!top!! < INSTANT — COLLECTION >

For information only, a typical installation would involve the following steps, but these should always be performed by a professional:

ON 17:00 | OFF 19:00 (Hot water for dishes and evening baths) Mid-day: Keep OFF to avoid "standing heat loss."

Repeat this process for additional programs (2 ON/OFF, 3 ON/OFF, etc.) if needed. Press to exit programming. D. Activate Automatic Mode kes geyser load control timer manual new

Before you start programming, it is helpful to know what the LEDs on your are telling you:

Press to select your day combination. Continue pressing to cycle through combinations, such as: Individual days (e.g., just Monday) Mon-Fri (Working week) Sat-Sun (Weekend) Mon-Wed-Fri or Tue-Thu-Sat For information only, a typical installation would involve

: Most restrictive; OFF for most of the day (00:00–03:00, 08:00–15:00, 20:00–24:00) and during peak times. It includes a short weekend "ON" window from 11:00 to 13:00.

Then she made coffee. At 6:17 AM. The geyser didn’t make a sound—it already knew she’d need the hot water in three minutes. Activate Automatic Mode Before you start programming, it

Complete Installation and Programming Guide for the KES Geyser Load Control Timer

Press and 'Min' to set the start time (e.g., 04:00 AM). Press 'Timer' again. You will see "1 OFF."

| Terminal | Label | Connection | |----------|-------|-------------| | 1 | L (IN) | Live incoming from geyser breaker (top of DB) | | 2 | L (OUT) | Live to geyser element | | 3 | N | Neutral (common) | | 4 | R1 | Ripple receiver/load limiter input signal (NO contact) | | 5 | R2 | Common for ripple signal | | 6 | Earth | Earth ground |

The geyser seems to be turning on and off at the wrong times. Possible Solution: