Install the soldering iron stand (anti-static) and the hot air gun holder.
Keep the workspace clear of volatile chemicals, alcohol-based flux cleaners, and loose paper. Hardware Overview and Interface
Warning: Cutting power early can ruin the heating element. Soldering Station Operation Power On: Press the Soldering Station ON/OFF button. gordak 952 user manual updated
Turn off the station, unplug it from the wall, and let the wand cool completely.
A heavy, grinding sound emerged from the machine's housing. It wasn't a motor starting; it was vocal cords clearing a throat of metal shavings. Install the soldering iron stand (anti-static) and the
Before plugging the station into a wall outlet for the first time, turn the unit upside down. You must locate and remove the red transit screw (or screws) anchoring the internal diaphragm pump to the chassis base. Leaving this screw intact restricts pump movement, causing severe vibration, deafening noise, and eventual motor burnout within minutes of activation. Initial Placement and Environment
Flip the machine over. You will find a bright red screw (or sometimes two) securing the internal pump. These are for shipping only. If you run the station with these in, the vibration will be loud enough to rattle your teeth and eventually destroy the pump motor. Check Your Grounding: Soldering Station Operation Power On: Press the Soldering
Adjusts the target temperature for the hot air stream.
Always clean and tin the tip with fresh solder before and after every use to prevent oxidation. Temperature Calibration Adjustment
Tighten the screw on the nozzle—do not force it.
The front panel features dedicated zones for both tools, allowing for independent operation. Left Section: Hot Air Rework Controls Toggles power to the hot air system.